导语

  

内容提要

  

    尼曼著的《电子电路分析与设计(第4版模拟电子技术影印版)(英文版)》主要讲解高级模拟电路，包括理想运算放大器及其应用、集成电路恒流偏置和有源负载及其在IC设计中的应用、差分及多级放大电路、反馈及稳定性、集成电路应用和设计，在IC应用中重点讲解有源滤波器和振荡器电路分析与设计。

PROLOGUE Ⅱ
PROLOGUE TO ELECTRONIC DESIGN
  Preview
  Design Approach
  System Design
  Electronic Design
  Conclusion
PART 2
  ANALOG ELECTRONICS
    Chapter 9  Ideal Operational Amplifiers and Op-Amp Circuits
      Preview
      9.1  The Operational Amplifier
      9.2  Inverting Amplifier
      9.3  Summing Amplifier
      9.4  Noninverting Amplifier
      9.5  Op-Amp Applications
      9.6  Operational Transconductance Amplifiers
      9.7  Op-Amp Circuit Design
      9.8  Design Application: Electronic Thermometer with an Instrumentation Amplifier
      9.9  Summary
      Problems
    Chapter 10    Integrated Circuit Biasing and Active Loads
      Preview
      10.1  Bipolar Transistor Current Sources
      10.2  FET Current Sources
      10.3  Circuits with Active Loads
      10.4  Small-Signal Analysis: Active Load Circuits
      10.5  Design Application: An NMOS Current Source
      10.6  Summary
      Problems
    Chapter 11     Differential and Multistage Amplifiers
      Preview
      11.1  The Differential Amplifier
      11.2  Basic BJT Differential Pair
      11.3  Basic FET Differential Pair
      11.4  Differential Amplifier with Active Load
      11.5  BiCMOS Circuits
      11.6  Gain Stage and Simple Output Stage
      11.7  Simplified BJT Operational Amplifier Circuit
      11.8  Diff-Amp Frequency Response
      11.9  Design Application: A CMOS Diff-Amp
      11.10 Summary
      Problems
    Chapter 12    Feedback and Stability
      Preview
      12.1  Introduction to Feedback
      12.2  Basic Feedback Concepts
      12.3  Ideal Feedback Topologies
      12.4  Voltage (Series-Shunt) Amplifiers
      12.5  Current (Shunt-Series) Amplifiers
      12.6  Transconductance (Series-Series) Amplifiers
      12.7  Transresistance (Shunt-Shunt) Amplifiers
      12.8  Loop Gain
      12.9  Stability of the Feedback Circuit
      12.10 Frequency Compensation
      12.11 Design Application: A MOSFET Feedback Circuit
      12.12 Summary
      Problems
    Chapter 13    Operational Amplifier Circuits
      Preview
      13.1  General Op-Amp Circuit Design
      13.2  A Bipolar Operational Amplifier Circuit
      13.3  CMOS Operational Amplifier Circuits
      13.4  BiCMOS Operational Amplifier Circuits
      13.5  JFET Operational Amplifier Circuits
      13.6  Design Application: A Two-Stage CMOS Op-Amp to Match a Given Output Stage
      13.7  Summary
      Problems
    Chapter 14    Nonideal Effects in Operational Amplifier Circuits
      Preview
      14.1  Practical Op-Amp Parameters
      14.2  Finite Open-Loop Gain
      14.3  Frequency Response
      14.4  Offset Voltage
      14.5  Input Bias Current
      14.6  Additional Nonideal Effects
      14.7  Design Application: An Offset Voltage Compensation Network
      14.8  Summary
      Problems
    Chapter 15    Applications and Design of Integrated Circuits
      Preview
      15.1  Active Filters
      15.2  Oscillators
      15.3  Schmitt Trigger Circuits
      15.4  Nonsinusoidal Oscillators and Timing Circuits
      15.5  Integrated Circuit Power Amplifiers
      15.6  Voltage Regulators
      15.7  Design Application: An Active Bandpass Filter
      15.8  Summary
      Problems
Appendix A  Physical Constants and Conversion Factors
Appendix B  Selected Manufacturers' Data Sheets
Appendix C  Standard Resistor and Capacitor Values
Appendix D  Reading List
Appendix E  Answers to Selected Problems